2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

RESULT LIST OF CAN BUS WIRE CHECK: 
Symptom
Suspected Area
See page
The result of "CAN BUS WIRE CHECK" is "Open in CAN Main Bus Line".
Open in CAN Main Bus Line
Click here
The result of "CAN BUS WIRE CHECK" is "Short in CAN Bus Lines".
Short in CAN Bus Lines
Click here
The result of "CAN BUS WIRE CHECK" is "Short to B+ in CAN Bus Line".
Short to B+ in CAN Bus Line
Click here
The result of "CAN BUS WIRE CHECK" is "Short to GND in CAN Bus Line".
Short to GND in CAN Bus Line
Click here
The result of "CAN BUS WIRE CHECK" is "Open in One Side of CAN Branch Line".
Open in One Side of CAN Branch Line
Click here
COMMUNICATION STOP MODE TABLE: 
Symptom
Suspected Area
See page
"Engine" is not displayed on the intelligent tester.
ECM Communication Stop Mode
Click here
"ABS/VSC/TRAC" is not displayed on the intelligent tester.
Skid Control ECU Communication Stop Mode
Click here
"Steering Angle Sensor" is not displayed on the intelligent tester.
Steering Angle Sensor Communication Stop Mode
Click here
"Yaw Rate/Decelerate Sensor" is not displayed on the intelligent tester.
Yaw Rate Sensor Communication Stop Mode
Click here
"Air Conditioner" is not displayed on the intelligent tester.
Air Conditioning Amplifier Communication Stop Mode
Click here
"SRS Airbag" is not displayed on the intelligent tester.
Center Airbag Sensor Communication Stop Mode
Click here
"Gateway" is not displayed on the intelligent tester.
Gateway ECU Communication Stop Mode
Click here
"Main Body" is not displayed on the intelligent tester.
Main Body ECU Communication Stop Mode
Click here
"Combination Meter" is not displayed on the intelligent tester.
Combination Meter ECU Communication Stop Mode
Click here
← HOW TO PROCEED WITH TROUBLESHOOTING (from Jun 2009)PROBLEM SYMPTOMS TABLE (from Jun 2009) →