HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
- HINT:
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Confirm problem symptoms (Click here).
| |||||
| 3.CHECK CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
- HINT:
- The center airbag sensor assembly is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
- Refer to the "Bus Check" for CAN communication system.
-
Click here for LHD with Smart Entry and Start System
-
Click here for LHD with Smart Entry and Start System
-
Click here for LHD without Smart Entry and Start System
-
Click here for LHD without Smart Entry and Start System
-
Click here for RHD with Smart Entry and Start System
-
Click here for RHD with Smart Entry and Start System
-
Click here for RHD without Smart Entry and Start System
-
Click here for RHD without Smart Entry and Start System
- Result:
Result
Proceed to
CAN communication DTC is not output.
A
CAN communication DTC is output.
B
|
|||||
| |||||
| 4.SRS WARNING LIGHT CHECK |
| |||||
| 5.CHECK FOR DTC (Present and Past DTCs)* |
Check for DTC outputs.
- Result:
Result
Proceed to
DTC is output.
A
DTC is not output.
B
|
|||||
| |||||
| 6.DTC CHART |
| |||||
| 7.CIRCUIT INSPECTION* |
| |||||
| 8.REPAIR |
| |||||
| 9.CLEAR DTC (Present and Past DTCs)* |
| |||||
| 10.CHECK FOR DTC (Present and Past DTCs)* |
Check for DTC outputs.
- Result:
Result
Proceed to
DTC is not output.
A
DTC is output.
B
|
|||||
| |||||
| 11.CONFIRMATION TEST |
| |||||