B2286 Runnable Signal Malfunction
Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This DTC is output when serial communication signals and CAN communication signals in the circuit between the main body ECU and ECM are inconsistent.- HINT:
- When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2286 |
Serial communication signals and CAN communication signals in the circuit between the main body ECU and ECM are inconsistent. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK OPERATION OF TACHOMETER |
Run the engine and check if the function of the tachometer in the combination meter is normal.
- OK:
- Actual engine revolution speed and the revolution indicated on the tachometer are the same.
|
|
||||
| OK | |
| 2. CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM) |
Delete the DTCs (Click here).
Check for CAN communication system DTC (for LHD: Click here), (for RHD: Click here).
- HINT:
- If the DTCs for the CAN communication system malfunction are output, inspect those DTCs first (for LHD: Click here), (for RHD: Click here).
- OK:
- No DTC is output.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the A55*1 or A24*2 ECM connector.


Disconnect the E8 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E8-8 (TACH) - A55-15 (TACH)*1
E8-8 (TACH) - A24-15 (TACH)*2
Always
Below 1 Ω
E8-8 (TACH) or A55-15 (TACH) - Body ground*1
E8-8 (TACH) or A24-15 (TACH) - Body ground*2
Always
10 kΩ or higher
- HINT:
- *1: LHD
- *2: RHD
|
|
||||
| OK | |
| 4. READ VALUE USING INTELLIGENT TESTER |
Reconnect the connectors.
Connect the intelligent tester to the DLC3.
Check the DATA LIST for proper functioning of the engine.
- HINT:
- When using the intelligent tester with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 second intervals or less until communication between the tester and vehicle starts.
Body: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
E/G Cond
Engine condition/STOP or RUN
STOP: Engine is stopped
RUN: Engine is running
-
- OK:
- STOP (engine is stopped) and RUN (engine is running) appear on the screen.
|
|
||||
| OK | ||
| ||
