Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Be sure to perform the SYMPTOM SIMULATION procedure before replacing the ECM. If these symptoms do not persist, the cause of the problem may be poor intermittent electrical contact (open or short) of a wire harness or connector.


Cruise control system 
Symptom
Suspected Area
See page
Vehicle speed cannot be set. (The CRUISE main indicator light comes on.)
1. Cruise control switch circuit
Click here
2. Combination meter
Click here
3. Vehicle speed sensor circuit
Click here
4. Stop light switch circuit
Click here
5. Transmission range sensor circuit (U250E)
Click here
5. Park/Neutral position sensor circuit (U660E)
Click here
6. Clutch switch circuit (M/T)
Click here
7. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. (2AZ-FE)
Click here
7. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. (2GR-FE)
Click here
Pushing the ON-OFF button does not turn the cruise control system on. (Vehicle speed cannot be set.)
1. Stop light switch circuit
Click here
2. Clutch switch circuit (M/T)
Click here
3. Vehicle speed sensor circuit
Click here
4. Cruise control switch circuit
Click here
5. Transmission range sensor circuit (U250E)
Click here
5. Park/Neutral position sensor circuit (U660E)
Click here
6. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. (2AZ-FE)
Click here
6. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. (2GR-FE)
Click here
The cruise control is canceled while it is operating.
1. Stop light switch circuit
Click here
2. Clutch switch circuit (M/T)
Click here
3. Transmission range sensor circuit (U250E)
Click here
3. Park/Neutral position sensor circuit (U660E)
Click here
4. Cruise control switch circuit
Click here
5. Vehicle speed sensor circuit
Click here
6. Combination meter
Click here
7. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. (2AZ-FE)
Click here
7. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. (2GR-FE)
Click here
Pulling back on the control main switch does not cancel the cruise control. (The CRUISE main indicator light remains on.)
1. Cruise control switch circuit
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2AZ-FE)
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2GR-FE)
Click here
Pulling back on the control main switch does not cancel the cruise control. (The CRUISE main indicator light goes off.)
Replace ECM (2AZ-FE)
Click here
Replace ECM (2GR-FE)
Click here
The cruise control is not canceled when vehicle speed drops below the low speed limit. (The CRUISE main indicator light remains on.)
1. Vehicle speed sensor circuit
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2AZ-FE)
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2GR-FE)
Click here
The cruise control is not canceled when vehicle speed drops below the low speed limit. (The CRUISE main indicator light goes off.)
Replace ECM (2AZ-FE)
Click here
Replace ECM (2GR-FE)
Click here
Depressing the brake pedal does not cancel the cruise control. (The CRUISE main indicator light remains on.)
1. Stop light switch circuit
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2AZ-FE)
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2GR-FE)
Click here
Depressing the brake pedal does not cancel the cruise control. (The CRUISE main indicator light goes off.)
Replace ECM (2AZ-FE)
Click here
Replace ECM (2GR-FE)
Click here
Depressing the clutch pedal does not cancel the cruise control. (The CRUISE main indicator light remains on.)
1. Clutch switch circuit (M/T)
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2AZ-FE)
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2GR-FE)
Click here
Depressing the clutch pedal does not cancel the cruise control. (The CRUISE main indicator light goes off.)
Replace ECM (2AZ-FE)
Click here
Replace ECM (2GR-FE)
Click here
Moving the shift lever does not cancel the cruise control
1. Transmission range sensor circuit (U250E)
Click here
1. Park/Neutral position sensor circuit (U660E)
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2AZ-FE)
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2GR-FE)
Click here
Hunting (Speed is not constant.)
1. Vehicle speed sensor circuit
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2AZ-FE)
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2GR-FE)
Click here
The CRUISE main indicator light remains blinking
1. TC and CG terminal circuit
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2AZ-FE)
Click here
2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. (2GR-FE)
Click here