Home › TRANSMISSION ยท E351 MANUAL TRANSAXLE › DIFFERENTIAL OIL SEAL

DIFFERENTIAL OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL


    D025722E02
  1. Coat a new oil seal lip with MP grease.

  1. Using SST and a hammer, install the oil seal.

    SST
    09608-10010  
    09950-70010   (09951-07200)

    Installation depth:
    -0.5 to 0.5 mm (-0.020 to 0.020 in.)

    NOTICE:
    Be careful not to damage the oil seal lip.



2. INSTALL TRANSAXLE CASE OIL SEAL


    D026133E04
  1. Coat a new oil seal lip with MP grease.

  1. Using SST and a hammer, install the oil seal.

    SST
    09608-32010  
    09950-70010   (09951-07200)

    Installation depth:
    3.0 to 4.0 mm (0.1181 to 0.1575 in.)

    NOTICE:
    Be careful not to damage the oil seal lip.



3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Click here.


4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



5. INSTALL FRONT WHEELS

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



6. ADD MANUAL TRANSAXLE OIL


    D025304E01
  1. Park the vehicle on a level place.

  1. Remove the filler plug and gasket.

  1. Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the filler plug opening.

    Oil grade:
    API GL-4 or GL-5

    Viscosity:
    SAE 75W-90

    NOTICE:
    1. Problems may occur if the oil level is too high or too low.
    2. After replacing the oil, drive the vehicle and check the oil level again.

  1. Check for oil leakage if the oil level is low.

  1. Install the filler plug and a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



7. INSPECT MANUAL TRANSAXLE OIL


8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Click here.


9. CHECK ABS SPEED SENSOR SIGNAL
ABS: (Click here).
VSC: (Click here).