Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/ Entry and Start System)

THEFT DETERRENT SYSTEM (w/ Entry and Start System) > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. Use this procedure to troubleshoot the theft deterrent system.
  2. The intelligent tester should be used in step 4 and 7-(c).



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard Voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use the intelligent tester to check that the CAN communication system functions normally.

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output (for LHD)
      B
      CAN DTC is output (for RHD)
      C



    B.
    GO TO CAN COMMUNICATION SYSTEM (for LHD) (Click here)

    C.
    GO TO CAN COMMUNICATION SYSTEM (for RHD) (Click here)
    A


    5.SYMPTOM SIMULATION

      NEXT


      6.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).
        Result 
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table
        A
        Fault is listed in Problem Symptoms Table
        B



      B.
      Go to step 8
      A


      7.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
      1. System Description (Click here)

      2. Terminals of ECU (Click here)

      3. Data List / Active Test (Click here)


      NEXT


      8.ADJUST, REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END