SKID CONTROL SENSOR > INSTALLATION |
| 1. INSTALL SKID CONTROL SENSOR |
![]() |
Clean the contact surface between the rear axle hub and bearing assembly and a new skid control sensor.
Place the skid control sensor on the rear axle hub and bearing assembly so that the connector is positioned as shown in the illustration.
![]() |
Using SST, a press, 2 V-blocks, and 2 steel plates, install the skid control sensor to the rear axle hub and bearing assembly.
| 2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR |
![]() |
Install the hub and bearing assembly with the 4 bolts.
Connect the skid control sensor connector.
| 3. INSPECT REAR AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, check for looseness near the center of the axle hub.
| 4. INSPECT REAR AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
| 5. INSTALL REAR DISC |
![]() |
Aligning the matchmarks, install the rear disc.
| 6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the rear disc brake caliper with the 2 bolts.
![]() |
Install the rear flexible hose with the bolt.
| 7. CONNECT SKID CONTROL SENSOR WIRE |
![]() |
Connect the connector to the skid control sensor.
| 8. INSTALL REAR WHEEL |
| 9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |
| 10. CHECK SPEED SENSOR SIGNAL |