Home › Engine / Hybrid System › 2AR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › 2011.10–2013.07
RM19V0EQ _51 Engine / Hybrid System _014574 2AR-FE ENGINE MECHANICAL _0073930 REAR CRANKSHAFT OIL SEAL A

2AR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 30300 1.REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

Hide 2.REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY (for Manual Transaxle)

Hide 31407B 3.REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY (for Manual Transaxle)

Hide 4.REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY (for Manual Transaxle)

Hide 31483 5.REMOVE CLUTCH RELEASE CYLINDER TO BLEEDER TUBE (for Manual Transaxle)

Hide 30500 6.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

Hide 31210 7.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

Hide 31250 8.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

Hide 13405 9.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

a.
A195875
1.375,1.26 0.854,1.26 false 1.292,0.781 1.146,0.781 1.146,0.781 1.146,1.26 false 0.49,1.177 0.823,1.333 0.333,0.156 10 false SST

Using SST, hold the crankshaft pulley.

SST
09213-54015  
09330-00021  

HINT:

SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)



b.
A210160

Remove the 8 bolts and flywheel sub-assembly.


Hide 32101 10.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

a.
A195875
1.375,1.26 0.854,1.26 false 1.292,0.781 1.146,0.781 1.146,0.781 1.146,1.26 false 0.49,1.177 0.823,1.333 0.333,0.156 10 false SST

Using SST, hold the crankshaft pulley.

SST
09213-54015  
09330-00021  

HINT:

SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)



b.
A196849

Remove the 8 bolts, front drive plate spacer, drive plate and ring gear sub-assembly, and rear drive plate spacer.


Hide 11401L 11.REMOVE REAR ENGINE OIL SEAL

a.
A293109
2.813,1.646 2.813,1.521 2.813,1.521 3.083,1.01 false 2.74,1.667 3.052,1.823 0.313,0.156 10 *a
*a Cut Position


Using a knife, cut off the lip of the oil seal.


b.

Using a screwdriver, pry out the oil seal.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the surface of the oil seal press fit hole or the crankshaft.