Home › Engine / Hybrid System › 2AR-FE LUBRICATION › ENGINE OIL COOLER
RM19V0EQ _51 Engine / Hybrid System _014579 2AR-FE LUBRICATION _0073964 ENGINE OIL COOLER A

2AR-FE LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

Clean the oil cooler contact surface on the engine.


b.

Apply a light coat of engine oil to 3 new gaskets.


c.

Install the 3 new gaskets to the oil cooler.


d.

Temporarily install the oil cooler with the union bolt, nut and a new seal washer.


e.
A207599C03
0.552,1.188 0.74,1.104 true 1.083,1.604 1.354,1.271 true 1.938,0.917 1.625,1.094 true 2.042,1.281 2.219,1.458 0.177,0.177 10 true 1 0.771,0.5 0.896,0.677 0.125,0.177 10 true 2 0.375,1.146 0.563,1.323 0.188,0.177 10 true *3 0.906,1.594 1.094,1.771 0.188,0.177 10 true *2 1.969,0.781 2.156,0.958 0.188,0.177 10 true *1
*1 Union Bolt
*2 Seal Washer
*3 Nut


Tighten the bolt and nut in several steps in the sequence shown in the illustration.

Torque:
Union Bolt : 60 N*m (612 kgf*cm, 44 ft.*lbf)
Nut : 10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 11452 2.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 25051 3.INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

Hide 6.INSPECT FOR OIL LEAK