Home › Drivetrain › U760E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM19V0EQ _52 Drivetrain _014582 U760E AUTOMATIC TRANSMISSION / TRANSAXLE _0073978 PARK / NEUTRAL POSITION SWITCH A

U760E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Move the shift lever to N.


b.
C135733C15
2.532,0.661 2.697,0.821 0.165,0.16 10 *a 1.701,1.332 2.499,0.754 2.499,0.754 1.699,1.456 false
*a Protrusion


Align the protrusions of the park/neutral position switch assembly.


c.

Install the park/neutral position switch assembly to the manual valve lever shaft sub-assembly with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:
·

Before installing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to install the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral switch cannot be reinstalled correctly.

·

After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the switch are aligned.




d.

Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the nut and washer.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


e.

Connect the connector to the park/neutral position switch assembly.


f.

Connect the transmission control cable to the transmission control cable bracket with a new clip.


g.

Connect the transmission control cable to the transmission control shaft lever with the nut.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


h.

Connect the wire harness clamp.


Hide 2.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17801 3.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 4.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 17750A 5.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 84540 6.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION

Hide 12601B 7.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY