Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014583 CLUTCH _0073992 CLUTCH MASTER CYLINDER A

CLUTCH  CLUTCH MASTER CYLINDER  INSTALLATION  


PROCEDURE

Hide 31410 1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install a new gasket to the clutch master cylinder assembly.


b.

Install the clutch master cylinder assembly with the 2 nuts.

Torque:
12 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 2.CONNECT CLUTCH LINE

C135419

a.

Using a (10 mm) union nut wrench, connect the clutch line.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



Hide 31434 3.CONNECT CLUTCH RESERVOIR TUBE

a.
C135418C01
1.073,1.625 1.073,1.427 1.073,1.427 2.021,1.094 false 1,1.656 1.271,1.948 0.271,0.292 10 false *a
*a Green Mark


Connect the clutch reservoir tube to the clutch master cylinder assembly with the clip.

NOTICE:
·

Connect the clutch reservoir tube so that it will not be twisted.

·

Make sure that the green mark is positioned as shown in the illustration.




Hide 31453 4.CONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.
C287079C01
0.802,0.396 0.854,0.385 false
V100135

MP grease


Apply MP grease to the contact surfaces of the clutch master cylinder push rod clevis pin and clutch master cylinder push rod clevis bushing.


b.

Connect the clutch master cylinder push rod clevis to the clutch pedal sub-assembly with the clutch master cylinder push rod clevis pin and a new clip.

HINT:

Install the clutch master cylinder push rod clevis pin from the left side of the vehicle.



Hide 44610 5.INSTALL BRAKE BOOSTER ASSEMBLY

Hide 6.FILL BRAKE FLUID RESERVOIR

Hide 7.BLEED CLUTCH LINE

Hide 9.INSPECT FOR FLUID LEAK

HINT:

Check for leaks in the clutch system.


Hide 10.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY