33820B
1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
Install the transmission control cable assembly with the 2 bolts.
Install the transmission control cable assembly to the control cable bracket with 2 new clips.
Install the 2 new clips.
| *1 | Transmission Control Cable Assembly Lock |
| *a | Projecting Part |
Install the transmission control cable assembly to the floor shift lever assembly.
The projecting part of the transmission control cable assembly should face upward when connected.
After installation, make sure that the transmission control cable assembly lock is projecting from A as shown in the illustration.
| *1 | Transmission Control Shift Cable |
Install the transmission control shift cable to the floor shift lever assembly.
| *1 | Adjuster Case |
| *2 | Lock Piece |
| *3 | Slider |
| *a | Before Lock Release |
| *b | Push Out |
| *c | Slide |
| *d | After Lock Release |
Release the lock of the cable length adjustment structure of the transmission control select cable.
Slide the slider.
Push the lock piece downward to release the lock.
| *1 | Outer Select Lever |
| *2 | Hole |
Align the hole of the outer select lever with the hole in the front transaxle case.
Insert a bolt into the aligned holes to secure the outer select lever in place.
Do not push in the bolt forcefully or damage the front transaxle case.
Use a bolt with a diameter of 6 mm (0.236 in.) and a length of at least 16 mm (0.630 in.).
Depending on the bolt diameter, it may be difficult to insert the bolt. In that case, use a bolt with a diameter smaller than 6 mm (0.236 in.).
| *1 | Slider Shaft |
| *2 | Cam Wall |
Push the slider shaft until it contacts the cam wall.
Do not pull up the pull collar.
When adjusting the cable, make sure that the shift lever is not in the 1st or 2nd gear position.
| *1 | Transmission control select cable |
| *2 | Lock Piece |
Install the transmission control select cable to the floor shift lever assembly with a new clip.
Make sure that the lock piece protrudes from the adjuster case.
When adjusting the cable, make sure that the shift lever is not in the 1st or 2nd gear position.
Press in the lock piece to the adjuster case.
Securely press in the lock piece until the lock engages.
Remove the bolt to release the select outer lever.
78110K
2.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY
58995A
3.INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET
89170
4.INSTALL CENTER AIRBAG SENSOR ASSEMBLY
5.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17801
6.INSTALL AIR CLEANER FILTER ELEMENT
17735
7.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
17750A
8.INSTALL INLET AIR CLEANER ASSEMBLY
12601B
9.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY