43420
1.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Coat the spline of the front drive inboard joint assembly with oil.
Be sure to use the same type of oil that is used for the transaxle.
Coat the lip of the transaxle case oil seal with MP grease (for Automatic Transaxle).
Coat the lip of the transmission case oil seal with MP grease (for Manual Transaxle).
Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly LH.
Face the end gap of the front drive shaft hole snap ring LH downward.
Do not damage the transaxle case oil seal (for Automatic Transaxle).
Do not damage the transmission case oil seal (for Manual Transaxle).
Do not damage the front axle inboard joint boot.
Make sure to center the front drive shaft assembly LH during installation to prevent damage to the front drive shaft hole snap ring LH.
Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.
| *a | Matchmark |
Align the matchmarks and install the front drive shaft assembly LH to the front axle hub sub-assembly.
Be careful not to damage the front axle outboard joint boot or speed sensor rotor.
43410
2.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Coat the spline of the front drive inboard joint assembly with oil.
Be sure to use the same type of oil that is used for the transaxle.
Coat the lip of the front transaxle case oil seal with MP grease (for Automatic Transaxle).
Coat the lip of the transaxle case oil seal with MP grease (for Manual Transaxle).
Install a new bearing bracket hole snap ring to the front drive shaft assembly RH.
Install the front drive shaft assembly RH.
Do not damage the front transaxle case oil seal (for Automatic Transaxle).
Do not damage the transaxle case oil seal (for Manual Transaxle).
Do not damage the front axle inboard joint boot.
When inserting the front drive shaft assembly RH, keep it level.
Install the bearing bracket hole snap ring and a new bolt.
| *a | Matchmark |
Align the matchmarks and install the front drive shaft assembly RH to the front axle hub sub-assembly.
Be careful not to damage the front axle outboard joint boot or speed sensor rotor.
48069
3.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
45470
4.CONNECT TIE ROD ASSEMBLY
89543
5.INSTALL FRONT SPEED SENSOR
48810
6.INSTALL FRONT STABILIZER LINK ASSEMBLY
43502H
7.INSTALL FRONT AXLE SHAFT NUT
Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using a non-residue solvent.
Be sure to perform this work even when using a new drive shaft.
Keep the threaded parts free of oil and foreign matter.
Using a socket wrench (30 mm), install the front axle shaft nut.
Using a chisel and a hammer, stake the front axle shaft nut.
8.INSTALL FRONT WHEELS
9.ADD AUTOMATIC TRANSAXLE FLUID (for Automatic Transaxle)
10.ADD MANUAL TRANSAXLE OIL (for Manual Transaxle)
11.INSPECT MANUAL TRANSAXLE OIL (for Manual Transaxle)
12.INSPECT FOR OIL LEAK (for Manual Transaxle)
53737B
13.INSTALL FRONT FENDER APRON SEAL LH
53736
14.INSTALL FRONT FENDER APRON SEAL RH
51442C
15.INSTALL ENGINE UNDER COVER LH
53852K
16.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for RHD)
51441C
17.INSTALL ENGINE UNDER COVER RH
53851Z
18.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)
19.ADJUST FRONT WHEEL ALIGNMENT
20.CHECK FOR SPEED SENSOR SIGNAL