Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM19V0EQ _52 Drivetrain _014586 AXLE AND DIFFERENTIAL _0074014 REAR AXLE HUB G

AXLE AND DIFFERENTIAL  REAR AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42491 3.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 42431 4.REMOVE REAR DISC

Hide 5.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C249633

Using a dial indicator, check for looseness near the center of the rear axle hub.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.



If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.


Hide 6.INSPECT REAR AXLE HUB RUNOUT

a.
C249634

Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolt.

Maximum runout:

0.07 mm (0.00276 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolt.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.



If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.


Hide 42431 7.INSTALL REAR DISC

Hide 42491 8.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 9.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 10.ADJUST PARKING BRAKE

Hide 11.INSTALL REAR WHEEL

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)