1.INSTALL HOLE PLUG
for Automatic Transaxle:
Install 9 hole plugs to the front frame assembly.
for Manual Transaxle:
Install 10 hole plugs to the front frame assembly.
52217E
2.INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION LH
| *a | View from Underneath |
|
Front of the Vehicle |
Temporarily install a new front suspension member body mounting rear cushion LH while confirming the installation direction.
Position the front suspension member body mounting rear cushion LH in the correct direction.
| *1 | Front Suspension Member Body Mounting Rear Cushion LH |
Install SST as shown in the illustration.
| *a | Hold |
| *b | Turn |
Using SST, install the front suspension member body mounting rear cushion LH as shown in the illustration.
Check that there is no clearance between the front suspension member and the front suspension member body mounting rear cushion LH.
52215
3.INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION RH
| *a | View from Underneath |
|
Front of the Vehicle |
Temporarily install a new front suspension member body mounting rear cushion RH while confirming the installation direction.
Position the front suspension member body mounting rear cushion RH in the correct direction.
Install SST using the same procedure as the front suspension member body mounting rear cushion LH.
Using SST, install the front suspension member body mounting rear cushion RH.
Perform the same procedure as the LH side.
52211J
4.INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING FRONT CUSHION
| *a | View from Underneath |
|
Front of the Vehicle |
Temporarily install a new front suspension member body mounting front cushion while confirming the installation direction.
Position the front suspension member body mounting front cushion in the correct direction.
Install SST using the same procedure as the front suspension member body mounting rear cushion LH.
| *a | Hold |
| *b | Turn |
Using SST, install the front suspension member body mounting front cushion as shown in the illustration.
Check that there is no clearance between the front suspension member and the front suspension member body mounting front cushion.
52216B
5.INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR STOPPER
Install the 2 front suspension member body mounting rear stoppers to the front frame assembly.
52213A
6.INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING FRONT STOPPER
Install the 2 front suspension member body mounting front stoppers to the front frame assembly.
51227B
7.INSTALL FRONT SUSPENSION MEMBER DYNAMIC DAMPER
Install the front suspension member dynamic damper to the front frame assembly with the 2 bolts.
48069
8.INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.
Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration.
While keeping the nut from rotating, tighten the bolt.
48068
9.INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
10.INSTALL STEERING LINK ASSEMBLY
11.INSTALL FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY
Install the front stabilizer bar with 2 front stabilizer link assemblies to the front frame assembly.
48829A
12.INSTALL FRONT NO. 1 STABILIZER BRACKET LH
48824A
13.INSTALL FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as the LH side.
51100G
14.INSTALL FRONT FRAME ASSEMBLY