Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL(for LHD) › 2011.10–2016.05
RM19V0EQ _54 Brake _014595 PARKING BRAKE _0074053 PARKING BRAKE PEDAL(for LHD) A

PARKING BRAKE  PARKING BRAKE PEDAL(for LHD)  INSTALLATION  


PROCEDURE

Hide 46201 1.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

a.
C237836N01
2.375,0.792 2.49,0.958 0.115,0.167 10 1 1.885,0.063 2,0.229 0.115,0.167 10 2 1.094,1.302 1.208,1.469 0.115,0.167 10 3

Install the parking brake control pedal assembly with the bolt and 2 nuts.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Tighten the bolt and 2 nuts in the order shown in the illustration.



b.

Connect the parking brake switch connector.


c.
C239419

Install the No. 1 parking brake cable assembly with the bolt and 2 nuts.

Torque:
Bolt : 15 N*m (153 kgf*cm, 11 ft.*lbf)
Nut : 5.4 N*m (55 kgf*cm, 48 in.*lbf)


d.

Install the clip to the No. 1 parking brake cable assembly.


e.

Install the floor carpet.


f.
C237832C01
2.302,1.542 2.302,0.927 2.302,0.927 2.573,0.927 true 2.896,1.542 2.896,0.865 2.896,0.865 2.729,0.865 true 2.25,1.563 2.573,1.823 0.323,0.26 10 false *1 2.854,1.552 3.146,1.823 0.292,0.271 10 false *2
*1 Lock Nut
*2 Adjusting Nut


Temporarily install the lock nut.

HINT:

After adjusting parking brake pedal travel, tighten the lock nut.



Hide 46440 2.CONNECT NO. 4 PARKING BRAKE CABLE ASSEMBLY

a.
C274275C02
1.177,0.5 1.49,0.656 0.313,0.156 10 *a 2.115,0.938 2.427,1.094 0.313,0.156 10 *b
*a Turn
*b Hold


Connect the No. 4 parking brake cable assembly to the parking brake control pedal assembly as shown in the illustration.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 58543B 4.INSTALL FLOOR CARPET BRACKET RH

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 9.ADJUST PARKING BRAKE PEDAL TRAVEL

Hide 10.INSPECT BRAKE WARNING LIGHT