Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.10–2016.05
RM19V0EQ _55 Steering _014596 POWER ASSIST SYSTEMS _0074061 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1541/13  Vehicle Speed Signal  


DESCRIPTION

The power steering ECU assembly receives vehicle speed signals from the brake actuator assembly via CAN communication. The ECU provides appropriate assisting force in accordance with the vehicle speed based on the signals.

If the ECU detects this DTC, it adjusts the amount of power assistance for a speed of 140 km/h (87 mph) and continues system control.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition
C1541/13 Vehicle Speed Signal This DTC is detected when vehicle speed signals via CAN communication are cut off for 3 seconds or more.
·

Speed sensor circuit

·

Brake actuator assembly

·

CAN communication system

·

Power steering ECU assembly


EPS Warning Light: Comes on Ignition switch ON again

INSPECTION PROCEDURE

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Check if DTC U0129/42 is output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM

Result:
Result Proceed to
U0129/42 is not output. A
U0129/42 is output. B


HINT:

DTC U0129/42 indicates a brake actuator assembly communication malfunction in the power steering system.




A

2.CHECK OTHER DTC OUTPUT (BRAKE CONTROL SYSTEM)

B

2.CHECK OTHER DTC OUTPUT (BRAKE CONTROL SYSTEM)
a.

Check for brake control system DTCs.

w/o VSC: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR

w/ VSC: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
OK:

Vehicle stability control system DTCs are not output.



Result:
Proceed to
OK
NG



OK

REPLACE POWER STEERING ECU ASSEMBLY

NG