Home › Audio / Visual / Telematics › AUDIO / VIDEO › INSTRUMENT PANEL SPEAKER › 2011.10–2014.05
RM19V0EQ _56 Audio / Visual / Telematics _014599 AUDIO / VIDEO _0074071 INSTRUMENT PANEL SPEAKER A

AUDIO / VIDEO  INSTRUMENT PANEL SPEAKER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION (for 10 Speakers)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 62312B 2.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 62212 3.REMOVE FRONT PILLAR GARNISH (w/o Curtain Shield Airbag)

Hide 62212 4.REMOVE FRONT PILLAR GARNISH (w/ Curtain Shield Airbag)

Hide 55408F 5.REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

Hide 86160P 6.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

a.
E231530

Remove the 2 screws.


b.
E226777

Lift the front No. 2 speaker assembly and disconnect the connector to remove the speaker.

NOTICE:

Do not touch the speaker cone.



Hide 7.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for 10 Speakers)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 8.REMOVE REAR CONSOLE BOX ASSEMBLY (for 10 Speakers)

Hide 58916 9.REMOVE BOX BOTTOM MAT (for 10 Speakers)

Hide 58804A 10.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for 10 Speakers)

Hide 11.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for 10 Speakers)

Hide 55660 12.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for 10 Speakers)

Hide 13.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for 10 Speakers)

Hide 55510F 14.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY (for 10 Speakers)

Hide 86160J 15.REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers)

a.
E223721

Remove the 2 screws.


b.
E223722

Lift the front No. 3 speaker assembly and disconnect the connector to remove the speaker.

NOTICE:

Do not touch the speaker cone.