Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM19V0EQ _56 Audio / Visual / Telematics _014599 AUDIO / VIDEO _0074079 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

Hide 72693 2.REMOVE REAR SEAT CUSHION LOCK HOOK (for Fixed Seat Type)

Hide 3.REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)

Hide 72693 4.REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)

Hide 5.REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)

Hide 6.REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)

Hide 86011R 7.REMOVE RADIO SETTING CONDENSER (for High Mounted Stop Light)

NOTICE:

When the terminal covers are removed, the radio setting condenser must be replaced because the terminal covers and condenser are supplied as a set.


a.
E223740

Remove the bolt.


b.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E226094

Disengage the claw and pull out the cover as shown in the illustration.


d.
E232601

Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.


e.
E223708

Using a screwdriver, bend back and break off the claw as shown in the illustration.


f.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the wire harness on the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.




Hide 62332A 8.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Window Defogger)

Hide 62472A 9.REMOVE ROOF SIDE INNER GARNISH LH (for Window Defogger)

Hide 86011Q 10.REMOVE RADIO SETTING CONDENSER (for Window Defogger)

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E223739

Remove the bolt.


b.

Disengage the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E221953

Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.


d.
E227453

Using a screwdriver, bend back and break off the claw as shown in the illustration.


e.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the wire harness on the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.