1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. RECOVER REFRIGERANT FROM AIR CONDITIONING SYSTEM
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.REMOVE FRONT BUMPER ASSEMBLY
17750A
5.REMOVE INLET AIR CLEANER ASSEMBLY
16470
6.REMOVE RADIATOR RESERVE TANK ASSEMBLY
53510
7.REMOVE HOOD LOCK ASSEMBLY (for LHD)
53510
8.REMOVE HOOD LOCK ASSEMBLY (for RHD)
53216A
9.REMOVE UPPER RADIATOR SUPPORT
53294C
10.REMOVE RADIATOR SIDE DEFLECTOR LH
Disengage the 3 claws and guide, and remove the radiator side deflector LH as shown in the illustration.
53293C
11.REMOVE RADIATOR SIDE DEFLECTOR RH
Disengage the 3 claws and guide, and remove the radiator side deflector RH as shown in the illustration.
88711
12.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the condenser.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88710E
13.DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
Remove the bolt and disconnect the air conditioner tube and accessory assembly from the condenser.
Remove the O-ring from the air conditioner tube and accessory assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88460
14.REMOVE COOLER CONDENSER ASSEMBLY
Remove the 4 bolts.
Disengage the 2 guides and remove the cooler condenser assembly as shown in the illustration.