The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A45 | Vehicle Speed Sensor | A fail flag is transmitted from the skid control ECU. | ·
Vehicle stability control system ·
Blind spot monitor sensor RH ·
Blind spot monitor sensor LH |
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.
Check for DTCs of the vehicle stability control system.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Vehicle stability control system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC is output from the blind spot monitor sensor RH (Master) | B |
| DTC is output from the blind spot monitor sensor LH (Slave) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C