1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DRAIN ENGINE COOLANT
53851Z
3.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)
53852K
4.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (for RHD)
51441C
5.REMOVE ENGINE UNDER COVER RH
51442C
6.REMOVE ENGINE UNDER COVER LH
7.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
8.REMOVE FRONT BUMPER ASSEMBLY
17750A
9.REMOVE INLET AIR CLEANER ASSEMBLY
16470
10.REMOVE RADIATOR RESERVE TANK ASSEMBLY
Disconnect the radiator reserve tank hose.
Remove the 2 bolts and radiator reserve tank assembly.
16571C
11.DISCONNECT NO. 1 RADIATOR HOSE
Disconnect the No. 1 radiator hose.
16572D
12.DISCONNECT NO. 2 RADIATOR HOSE
Disconnect the No. 2 radiator hose and clamp.
32941
13.DISCONNECT INLET NO. 1 OIL COOLER HOSE (w/ Oil Cooler)
Disconnect the inlet No. 1 oil cooler hose.
32942
14.DISCONNECT OUTLET NO. 1 OIL COOLER HOSE (w/ Oil Cooler)
Disconnect the outlet No. 1 oil cooler hose.
53510
15.REMOVE HOOD LOCK ASSEMBLY (for RHD)
53510
16.REMOVE HOOD LOCK ASSEMBLY (for LHD)
53216A
17.REMOVE UPPER RADIATOR SUPPORT
Disconnect the connector. (for RHD)
Disconnect the 2 connectors. (for LHD)
| *A | for RHD |
| *B | for LHD |
Disconnect the hood lock control cable clamp and remove the 5 bolts and upper radiator support.
Remove the 2 radiator support cushions.
16400
18.REMOVE RADIATOR ASSEMBLY
Disconnect the 2 clamps and 2 connectors.
Remove the 4 bolts and separate the condenser assembly from the radiator assembly.
Remove the radiator assembly with fan assembly.
Do not apply any excessive force to the cooler condenser assembly or pipe when removing the radiator assembly.
Remove the 2 lower radiator supports.
Release the 3 claws and lift the fan assembly from the radiator.