Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR › from 2016.05
RM19V0EQ _54 Brake _014591 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0074035 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.

·

If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

·

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>INSTALLATION

HINT:
·

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.

·

If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.




Hide 2.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 89516D 4.CONNECT SKID CONTROL SENSOR WIRE

a.

Connect the connector to the rear speed sensor.


Hide 42431 5.INSTALL REAR DISC

Hide 42491 6.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 7.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 8.ADJUST PARKING BRAKE

Hide 9.INSTALL REAR WHEEL

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION