Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
42450B
1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
Install the rear axle hub and bearing assembly and parking brake assembly to the rear axle carrier sub-assembly with the 4 bolts.
2.INSPECT REAR AXLE HUB BEARING LOOSENESS
3.INSPECT REAR AXLE HUB RUNOUT
89516D
4.CONNECT SKID CONTROL SENSOR WIRE
42431
5.INSTALL REAR DISC
42491
6.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
7.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
8.ADJUST PARKING BRAKE
9.INSTALL REAR WHEEL
10.CHECK FOR SPEED SENSOR SIGNAL