46201
1.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY
Install the parking brake control pedal assembly with the bolt and 2 nuts.
Tighten the bolt and 2 nuts in the order shown in the illustration.
Connect the parking brake switch connector.
Install the No. 1 parking brake cable assembly with the bolt and 2 nuts.
Install the clip to the No. 1 parking brake cable assembly.
Install the floor carpet.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
Temporarily install the lock nut.
After adjusting parking brake pedal travel, tighten the lock nut.
46440
2.CONNECT NO. 4 PARKING BRAKE CABLE ASSEMBLY
| *a | Turn |
| *b | Hold |
Connect the No. 4 parking brake cable assembly to the parking brake control pedal assembly as shown in the illustration.
89170
3.INSTALL AIRBAG SENSOR ASSEMBLY
58543B
4.INSTALL FLOOR CARPET BRACKET RH
33525
5.INSTALL SHIFT LEVER SUPPORT
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
7. PERFORM DIAGNOSTIC SYSTEM CHECK
8.INSPECT SRS WARNING LIGHT
9.ADJUST PARKING BRAKE PEDAL TRAVEL
10.INSPECT BRAKE WARNING LIGHT