DTC C1434 Steering Angle Sensor Output Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1434 | Any of the following is detected:
|
|

| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON again and check that no CAN communication system DTC is output (Click here).
Start the engine.
Drive the vehicle at a speed of 35 km/h (22 mph) and turn the steering wheel to the right and left and then check that no speed sensor or yaw rate and acceleration sensor DTCs are output (Click here).
| Result | Proceed to |
| No CAN communication system, speed sensor, or yaw rate and acceleration sensor DTCs are output. | A |
| CAN communication system DTC is output. | B |
| Speed sensor and/or yaw rate and acceleration sensor DTC is output. | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK STEERING ANGLE SENSOR INSTALLATION |
Turn the ignition switch off.
Check that the steering angle sensor has been installed properly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
![]() |
Remove the steering wheel and the column cover.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the steering angle sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I29-5 (BAT) - Body ground | Always | 11 to 14 V |
| I29-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I29-1 (ESS) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Steering Angle Sensor) |
|
| ||||
| OK | ||
| ||