Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN DTC is not output.
      A
      CAN DTC is output.
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK FOR DTCs*
    1. Check for DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is not output.
      A
      DTC is output.
      B



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    5.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

    2. Result:
      Result
      Proceed to
      Problem symptom does not occur.
      A
      Problem symptom occurs.
      B



    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. Data List / Active Test (Click here).


    NEXT


    7.REPAIR

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END