DTC P0776 Pressure Control Solenoid "B" Performance (Shift Solenoid Valve SL2) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0776 | The gear required by the ECM does not match the actual gear when driving (2-trip detection logic) |
|
| PERFORM ACTIVE TEST |
Warm up the engine.
Turn the ignition switch off.
Connect the Intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn on the Intelligent tester.
Select the item "Enter / Powertrain / Engine and ECT / Active Test / Shift Status".
According to the display on the tester, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Control the Shift Position | [Test Details] Operate the shift solenoid valve and set each shift position by yourself. [Vehicle Condition]
| 1st / 2nd / 3rd / 4th | Possible to check the operation of the shift solenoid valves. |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0776) |
Connect the Intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the Intelligent tester main switch on.
Select the item "Enter / Powertrain / Engine and ECT / Trouble Codes".
Read the DTCs using the Intelligent tester.
| Display (DTC output) | Proceed to |
| Only "P0776" is output | A |
| "P0776" and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE SL2 |
![]() |
Remove the shift solenoid valve SL2.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
| *1 | Shift Solenoid Valve SL2 |
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly (Click here).
|
| ||||
| OK | |
| 4.INSPECT TORQUE CONVERTER ASSEMBLY |
Check the torque converter assembly (Click here).
|
| ||||
| OK | ||
| ||