Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Smart Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/ Smart Entry and Start System) > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.

Certification ECU (Smart Key ECU Assembly) 
DTC Code
Detection Item
Detection Enabling Condition (DTC Output Confirmation Operation)
See page
B2779
Engine Starter Communication Malfunction
Always
Click here
B2784
Antenna Coil Open / Short
With the shift lever in P, the key is held near the engine switch and an engine start operation is performed by pressing and holding the engine switch when the key battery is depleted.
Click here
B278A
Short to GND in Immobiliser System Power Source Circuit
With the shift lever in P, the key is held near the engine switch and an engine start operation is performed by pressing and holding the engine switch when the key battery is depleted.
Click here
B278D
Malfunction of ID-BOX Recognition
Always
Click here
B2790
*1
ID BOX EEPROM Malfunction
An immobiliser set/unset operation is performed (Turn the engine switch is off or on (IG) while carrying the key).
Click here
  1. *1: w/o Wireless Door Lock Buzzer Answer Back Function

ECM 
DTC Code
Detection Item
Detection Enabling Condition (DTC Output Confirmation Operation)
See page
B2799
Engine Immobiliser System Malfunction
Either condition is met:
- Within 10 seconds of an engine start operation being performed (with the shift lever in P and the brake pedal depressed, the engine switch is pressed while carrying the key). If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds).
- 10 seconds after the engine switch is turned on (IG) after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the engine switch being turned on (IG), and DTCs are stored after 6 seconds).
Click here
B279A
Theft Deterrent System Communication Line High Fixation
Turn the engine switch on (IG) and wait 6 seconds.
Click here
B279C
Theft Deterrent System Presence Detection
Check for DTCs.
Click here