Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › BLOCKING SYSTEM

BLOCKING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the blocking system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard Voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    3.START ENGINE
    1. Check that the engine starts normally.

      OK:
      Engine starts normally.



    NG.
    GO TO SMART ENTRY AND START SYSTEM (for Start Function) (Click here)
    OK


    4.CHECK DTC OUTPUT*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is not output.
      A
      SFI system DTC is output.
      B
      Engine immobiliser system DTC is output.
      C
      Smart entry and start system (for start function) DTC is output.
      D
      Blocking system DTC is output.
      E



    B.
    GO TO SFI SYSTEM (Click here)

    C.
    GO TO ENGINE IMMOBILISER SYSTEM (w/ Smart Entry and Start System) (Click here)

    D.
    GO TO SMART ENTRY AND START SYSTEM (for Start Function) (Click here)

    E.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    5.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in the problem symptoms table.
      A
      Fault is listed in the problem symptoms table.
      B



    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)


    NEXT


    7.REPAIR OR REPLACE

      NOTICE:
      1. When replacing the certification ECU (smart key ECU assembly), telephone transceiver assembly, instrument panel integration antenna assembly or mayday battery, refer to the Service Bulletin.
      2. When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.


    NEXT


    8.CONFIRMATION TEST

      NEXT

      END