VEHICLE STABILITY CONTROL SYSTEM > ABS Warning Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.CHECK ABS WARNING LIGHT |
Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Check that the ABS warning light comes on.
|
| ||||
| OK | ||
| ||
| 3.INSPECT COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Perform an Active Test of the combination meter assembly (meter CPU) using the Techstream (Click here).
Check the combination meter assembly.
|
| ||||
| OK | ||
| ||