DTC B1788 Rear Occupant Classification Sensor RH Collision Detection |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1788 |
|
|
| 1.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Using the Techstream, perform Zero Point Calibration and Sensitivity Check (Click here).
|
| ||||
| OK | |
| 2.CHECK DTC |
Clear the DTCs stored in the occupant detection ECU (Click here).
Clear the DTCs stored in the airbag sensor assembly (Click here for Separate Type Yaw Rate Sensor, Click here for Built-in Type Yaw Rate Sensor).
Turn the ignition switch off.
Turn the ignition switch to ON.
Check for DTCs (Click here).
Turn the ignition switch off.
|
| ||||
| OK | ||
| ||
| 3.REPLACE FRONT SEAT FRAME WITH ADJUSTER ASSEMBLY RH |
Disconnect the cable from the negative (-) battery terminal.
Replace the front seat frame with adjuster assembly RH (Click here for TMMK Made Manual Seat, Click here for TMMK Made Power Seat, Click here for SIA Made Manual Seat, Click here for SIA Made Power Seat).
Connect the cable to the negative (-) battery terminal.
| NEXT | |
| 4.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Using the Techstream, perform Zero Point Calibration and Sensitivity Check (Click here).
| NEXT | ||
| ||