POWER WINDOW CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| What | Vehicle model, system name |
| When | Date, time, occurrence frequency |
| Where | Road conditions |
| Under what conditions? | Driving conditions, weather conditions |
| How did it happen? | Problem symptoms |
| |||||
| 3.PRE-CHECK |
Measure the battery voltage.
Check the fuses and relays.
Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
| |||||
| 4.SYSTEM CHECK |
Check the vehicle specification.
| Result | Proceed to |
| w/ Smart Key System | A |
| w/o Smart Key System | B |
|
| ||||
| |||||
| 5.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the Techstream to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| ECU is connected, communication line is normal | A |
| ECU is connected, communication line is malfunctioning | B |
|
| ||||
| |||||
| 6.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
Use the Techstream to check if the LIN communication system is functioning normally (Click here).
| Result | Proceed to |
| No DTCs output | A |
| DTCs output | B |
|
| ||||
| |||||
| 7.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs.
Recheck for DTCs.
| Result | Proceed to |
| No DTCs output | A |
| DTCs output | B |
|
| ||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 9.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here)
Data List / Active Test (Click here)
Terminals of ECU (Click here)
| |||||
| 10.ADJUST, REPAIR OR REPLACE |
Check if driver door window regulator, power window regulator motor assembly LH (for driver door), door glass or door glass run has been removed and reinstalled.
| Result | Proceed to |
| Driver door window regulator, power window regulator motor assembly LH (for driver door), door glass or door glass run has been removed and reinstalled. | A |
| None of the driver door window regulator, power window regulator motor assembly LH (for driver door), door glass or door glass run has been removed and reinstalled. | B |
|
| ||||
| |||||
| 11.INITIALIZE POWER WINDOW REGULATOR MOTOR ASSEMBLY |
If the driver door window regulator or power window regulator motor assembly LH (for driver door) have been removed and reinstalled, perform "Initialize Power Window Control System" (initialization of the pulse sensor) for the driver door glass (Click here).
| |||||
| 12.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|