PARKING ASSIST MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
| |||||
| 3.CHECK AUDIO AND VISUAL SYSTEM |
Refer to the audio and visual system (for radio and display type with intuitive parking assist system) (Click here).
| Result | Proceed to |
| Audio and visual system is normal | A |
| Audio and visual system is abnormal | B |
|
| ||||
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the Techstream to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| CAN DTCs are not output. | A |
| CAN DTCs are output. | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
| Result | Proceed to |
| No DTCs are output. | A |
| DTCs are output. | B |
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING |
Diagnosis System (Click here)
Terminals of ECU (Click here)
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|