General
Symptom
| Suspected Area
| See page
|
When the shift lever is in R, the parking assist monitor image is not displayed (screen is not black).
| Audio and visual system (Reverse Signal Circuit)
|
Click here
|
Navigation ECU sub-assembly
|
Click here
|
When the shift lever is in R, the parking assist monitor image is not displayed (screen is black).
| Image from camera for parking assist monitor is abnormal
|
Click here
|
Navigation ECU sub-assembly
|
Click here
|
When the shift lever is not in R, the parking assist monitor image is displayed.
| Audio and visual system (Reverse Signal Circuit)
|
Click here
|
Navigation ECU sub-assembly
|
Click here
|
Parking Assist Monitor System Malfunction
Symptom
| Suspected Area
| See page
|
Projected course guide lines are not displayed.
| Parking assist monitor screen display mode settings. (Check if the parking guide lines are set to off.)
|
Click here
|
Navigation ECU sub-assembly
|
Click here
|
"System initializing" is displayed.
| Correct the steering angle neutral point
|
Click here
|
"System initializing" is displayed even after correcting the steering angle neutral point.
| Steering sensor
|
Click here
|
Steering angle setting (Calibration)
|
Click here
|
Navigation ECU sub-assembly
|
Click here
|
"System not ready" is displayed.
| Navigation ECU sub-assembly initialization (Calibration)
|
Click here
|
"System not ready" is displayed even after navigation ECU sub-assembly initialization.
| Navigation ECU sub-assembly
|
Click here
|
During parallel parking assist mode, the screen does not change even though the vehicle has moved.
| If the vehicle is reversing at very low speed, the screen may not change
| -
|
During parallel parking assist mode, the screen changes even though the vehicle has not moved.
| If the vehicle is stopped for extended period of time, the screen may change
| -
|
Guide lines and buttons are not displayed for all parking assist monitor screen display modes.
| Guide Lines and Buttons are not Displayed for All Display Modes
|
Click here
|
The guide lines and buttons remain displayed even though the luggage compartment door is open.
| CAN communication system
|
Click here
|
Guide Lines and Buttons are not Displayed for All Display Modes
|
Click here
|
When adjusting the camera optical axis, "Back door is open. Do not use the rear view monitor when the back door is not completely closed." is displayed even after the luggage compartment door has been closed.
| Guide Lines and Buttons are not Displayed for All Display Modes
|
Click here
|
"CHK" message(s) are displayed on the Car Signal Check screen.
| Car signal check (Diagnosis)
|
Click here
|
When the parking assist monitor screen is displayed, the lines are misaligned. (The image from the camera is tilted.)
| Back camera position setting (Calibration)
|
Click here
|