Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › REMOTE ENGINE STARTER SYSTEM

DTC    B126A    Remote Engine Starter ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is stored when BERKES communication between the remote engine starter ECU and main body ECU (multiplex network body ECU) stops for 10 seconds or more.

DTC No.
DTC Detection Condition
Trouble Area
B126A
No communication between remote engine starter ECU and main body ECU (multiplex network body ECU) for 10 seconds or more.
  1. Remote engine starter ECU
  2. Wire harness or connector
  3. Main body ECU (multiplex network body ECU)

WIRING DIAGRAM


B278899E02


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. Before replacing the remote engine starter ECU, refer to Registration (Click here).

1.CHECK HARNESS AND CONNECTOR (REMOTE ENGINE STARTER ECU - BATTERY AND BODY GROUND)
  1. Disconnect the I141 remote engine starter ECU connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I141-10 (R+B) - Body ground
    Always
    11 to 14 V
    I141-1 (RSIG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    I141-1 (RSIG) - Body ground
    Engine switch off
    Below 1 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I141-19 (RGN1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - REMOTE ENGINE STARTER ECU)
  1. Disconnect the I13 main body ECU (multiplex network body ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I13-25 (BTX) - I141-4 (BTX)
    Always
    Below 1 Ω
    I13-26 (BRX) - I141-3 (BRX)
    Always
    Below 1 Ω
    I13-25 (BTX) - Body ground
    Always
    10 kΩ or higher
    I13-26 (BRX) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE REMOTE ENGINE STARTER ECU
  1. Temporarily replace the remote engine starter ECU with a new one (Click here).


NEXT


4.REGISTER REMOTE ENGINE STARTER ID
  1. Register the remote engine starter ID (Click here).


NEXT


5.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Perform the remote engine start operation.

  1. Check for DTCs.

    OK:
    DTC B126A is not output.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (REMOTE ENGINE STARTER ECU WAS DEFECTIVE)