BLIND SPOT MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
| |||||
| 4.CHECK CAN COMMUNICATION SYSTEM* |
Use the Techstream to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC AND FREEZE FRAME DATA* |
Refer to DTC Check/Clear for the blind spot monitor system (Click here).
Record or print DTCs and freeze frame data, if necessary (Click here).
| Result | Proceed to |
| DTCs are output. | A |
| DTCs are not output. | B |
|
| ||||
| |||||
| 6.DTC CLEAR* |
Refer to DTC Check/Clear for the blind spot monitor system (Click here).
| |||||
| 7.RECHECK FOR DTC* |
Refer to DTC Check/Clear for the blind spot monitor system (Click here)
| Result | Proceed to |
| DTCs are output. | A |
| DTCs are not output. | B |
|
| ||||
| |||||
| 8.DIAGNOSTIC TROUBLE CODE CHART |
Find the output DTC in Diagnostic Trouble Code Chart (Click here)
|
| ||||
|---|---|---|---|---|---|
| 9.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table. | A |
| Fault is listed in Problem Symptoms Table. | B |
|
| ||||
| |||||
| 10.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM* |
Refer to Terminals of ECU (Click here).
Refer to Data List / Active Test (Click here).
| |||||
| 11.CIRCUIT INSPECTION |
| |||||
| 12.ADJUST, REPAIR OR REPLACE |
| |||||
| 13.PERFORM BEAM AXIS INSPECTION |
Perform the blind spot monitor beam axis inspection (Click here).
| |||||
| 14.PERFORM CONFIRMATION TEST* |
|
| ||||
|---|---|---|---|---|---|