Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074406 AIR FUEL RATIO SENSOR A

2GR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 89467B 3.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

a.
A255011

Disconnect the air fuel ratio sensor connector.


b.
A255012

Separate the wire harness clamp.


c.
A255013C01
1.792,1.448 1.479,1.927 1.479,1.927 1.302,1.927 true 0.979,1.854 1.281,2.156 0.302,0.302 10 SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.

SST
09224-00010  


Hide 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 89467B 5.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.
A255480

Disconnect the air fuel ratio sensor connector.


b.

Disconnect the harness clamp.


c.
A255015C01
1.781,1.26 2.042,1.26 true 2.094,1.177 2.396,1.552 0.302,0.375 10 SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.

SST
09224-00010