1.INSPECT INTAKE AIR CONTROL VALVE (for ACIS)
Perform the following inspection procedure when using the intelligent tester:
Stop the engine.
Remove the V-bank cover assembly.
Click hereEngine / Hybrid System>2GR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL
Connect the intelligent tester to the DLC3.
Start the engine and turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Active the VSV for Intake Control.
| Tester Display |
|---|
| Activate the VSV for Intake Control |
Make sure that a clicking sound is heard from the intake air control valve when current flows.
If the intake air control valve does not operate, check the ACIS control circuit.
Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>P0660
Install the V-bank cover assembly.
Click hereEngine / Hybrid System>2GR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION
Perform the following inspection procedure when applying voltage between the terminals:
Remove the V-bank cover assembly.
Click hereEngine / Hybrid System>2GR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL
Disconnect the connector from the intake air control valve.
Apply battery voltage between terminals 2 (+) and 1 (-) of the intake air control valve. Check that a clicking sound is heard from the intake air control valve.
If the operation is not as specified, replace the intake air surge tank assembly.
Install the V-bank cover assembly.
Click hereEngine / Hybrid System>2GR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION