16361A
1.REMOVE V-RIBBED BELT
2.DRAIN ENGINE COOLANT
16572D
3.DISCONNECT NO. 2 RADIATOR HOSE
12327A
4.REMOVE NO. 2 ENGINE MOUNTING STAY RH (for Engine Mounting stay Side)
12327A
5.REMOVE NO. 2 ENGINE MOUNTING STAY RH (for Intake Manifold Side)
12309
6.REMOVE ENGINE MOVING CONTROL ROD SUB-ASSEMBLY
12315
7.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH
Using SST, remove the bolt.
There is not enough clearance to completely remove the bolt from the front No. 1 engine mounting bracket LH. Remove the front No. 1 engine mounting bracket LH together with the bolt.
Remove the 5 bolts and front No. 1 engine mounting bracket LH.
16604
8.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
9.REMOVE V-RIBBED BELT TENSIONER PULLEY
Remove the 5 mm bi-hexagon wrench.
Remove the bolt and V-ribbed belt tensioner pulley and dust shield.
Do not turn the bolt labeled "L" counterclockwise.
Store the V-ribbed belt tensioner pulley so that the bearing does not get damaged.
16323
10.REMOVE WATER INLET HOUSING
| *1 | Water Hose |
| *2 | Water Inlet Housing |
Disconnect the water hose.
Remove the 2 bolts, nut and water inlet housing.
Remove the 2 O-rings.
16173
11.SEPARATE WATER PUMP PULLEY
Using SST, hold the water pump pulley.
Using SST and union nut wrench, remove the 4 bolts and separate the water pump pulley from the engine water pump.
There is not enough clearance to completely remove the water pump pulley from the water pump shaft. Remove the water pump pulley together with the engine water pump.
16100
12.REMOVE ENGINE WATER PUMP ASSEMBLY
Remove the 16 bolts, engine water pump assembly, water pump pulley and gasket.