Home › Engine / Hybrid System › 2GR-FE COOLING › WATER PUMP
RM2030EQ _51 Engine / Hybrid System _014639 2GR-FE COOLING _0074443 WATER PUMP G

2GR-FE COOLING  WATER PUMP  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

HINT:
·

Before performing this inspection, check that there is no coolant leaking from any parts other than the engine water pump assembly. If there are leaks, inspect those areas.

·

Perform this inspection when the engine is cold.



a.

Visually inspect the engine compartment for the following conditions:

i.

There is a large amount of coolant in the engine compartment or on the underside of the hood near the V-ribbed belt.


ii.

Liquid coolant is dripping from around the engine water pump assembly.


iii.

The coolant level in the reserve tank assembly is below the low line and there are traces of leakage around the engine water pump assembly.

If any of the above conditions exist, replace the engine water pump assembly.

If none of the above conditions exist, perform the following inspection (inspection of the area around the engine water pump assembly).




c.

Separate the water pump pulley.

Click hereEngine / Hybrid System>2GR-FE COOLING>WATER PUMP>REMOVAL

HINT:

Move the water pump pulley so that the drain plug can be reached.



d.

Inspect the area around the engine water pump assembly.

HINT:

Check for deposits around the drain plug of the engine water pump assembly.


i.
A232903
0.638,0.457 0.855,0.646 0.217,0.189 10 *1 1.319,1.041 0.991,0.556 0.991,0.556 0.891,0.556 false
*1 Drain Plug


Press a piece of paper towel against the drain plug or deposits on the lip of the drain plug and check that the paper towel is not wet.

If the paper towel is wet, replace the engine water pump assembly.

If the paper towel is not wet, thoroughly clean the area around the engine water pump assembly.



e.

Install the water pump pulley.

Click hereEngine / Hybrid System>2GR-FE COOLING>WATER PUMP>INSTALLATION


Hide 16100 2.INSPECT ENGINE WATER PUMP ASSEMBLY

a.
A253168

Turn the pulley and check that the water pump bearing moves smoothly and quietly.

If necessary, replace the engine water pump assembly.