1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DRAIN ENGINE COOLANT
53851Z
3.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
53852K
4.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
51441C
5.REMOVE ENGINE UNDER COVER RH
51442C
6.REMOVE ENGINE UNDER COVER LH
7.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
8.REMOVE BATTERY
9.REMOVE FRONT BUMPER ASSEMBLY
17752
10.REMOVE INLET NO. 2 AIR CLEANER
17751
11.REMOVE INLET NO. 1 AIR CLEANER
16470
12.REMOVE RADIATOR RESERVE TANK ASSEMBLY
Disconnect the radiator reserve tank hose.
Remove the 2 bolts and radiator reserve tank assembly.
16571C
13.DISCONNECT NO. 1 RADIATOR HOSE
Disconnect the No. 1 radiator hose.
16572D
14.DISCONNECT NO. 2 RADIATOR HOSE
Disconnect the No. 2 radiator hose and clamp.
32941
15.DISCONNECT INLET NO. 1 OIL COOLER HOSE
Disconnect the inlet No. 1 oil cooler hose.
32942
16.DISCONNECT OUTLET NO. 1 OIL COOLER HOSE
Disconnect the outlet No. 1 oil cooler hose.
53510
17.REMOVE HOOD LOCK ASSEMBLY (for LHD)
53510
18.REMOVE HOOD LOCK ASSEMBLY (for RHD)
53216A
19.REMOVE UPPER RADIATOR SUPPORT
Disconnect the 2 connectors.
| *A | for RHD |
| *B | for LHD |
Disconnect the hood lock control cable clamp and remove the 5 bolts and upper radiator support.
Remove the 2 radiator support cushions from the radiator assembly.
16400
20.REMOVE RADIATOR ASSEMBLY
Disconnect the 3 clamps and connector.
Remove the 4 bolts and separate the condenser assembly from the radiator assembly.
Remove the radiator assembly with fan assembly.
Do not apply any excessive force to the cooler condenser assembly or pipe when removing the radiator assembly.
Remove the 2 lower radiator supports from the radiator assembly.
Release the 3 claws and lift the fan assembly from the radiator.