Home › Engine / Hybrid System › 2GR-FE LUBRICATION › ENGINE OIL COOLER
RM2030EQ _51 Engine / Hybrid System _014640 2GR-FE LUBRICATION _0074453 ENGINE OIL COOLER A

2GR-FE LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

Clean the oil cooler assembly contact surface on the cooler mounting.


b.

Install a new O-ring to the oil cooler assembly.


c.
A136292

Install the oil cooler assembly with the union bolt.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


d.
A136291

Install the 2 water by-pass hoses with the bolt, 2 clamps and 4 clips.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 17105 2.INSTALL EXHAUST MANIFOLD ASSEMBLY LH

Hide 6.INSPECT FOR OIL LEAK

a.

Start the engine.


b.

Check for engine oil leaks from the oil cooler assembly and the union bolt.