Home › Engine / Hybrid System › 2GR-FE STARTING › STARTER
RM2030EQ _51 Engine / Hybrid System _014641 2GR-FE STARTING _0074455 STARTER A

2GR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 53295E 2.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 11209 4.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 17752 5.REMOVE INLET NO. 2 AIR CLEANER

Hide 17751 7.REMOVE INLET NO. 1 AIR CLEANER

Hide 17735 8.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 9.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17701 10.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 28100 11.REMOVE STARTER ASSEMBLY

a.
A255475

Disconnect the starter connector.


b.

Remove the terminal cap.


c.

Remove the nut and disconnect the starter wire.


d.
A255476

Remove the 2 bolts and starter.