Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0074467 PARK / NEUTRAL POSITION SWITCH A

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17752 2.REMOVE INLET NO. 2 AIR CLEANER

Hide 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 4.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 33820B 6.SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C239656

Disconnect the wire harness clamp.


c.
C239668

Remove the nut from the transmission control shaft lever.


d.

Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.


Hide 84540 7.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Disconnect the connector from the park/neutral position switch.


b.
C136685

Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.


c.
C239670

Remove the 2 bolts and park/neutral position switch assembly from the manual valve lever shaft sub-assembly.

NOTICE:

Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the park/neutral position switch assembly straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.