Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › TCM
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0074474 TCM A

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  TCM  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

If automatic transaxle parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary.

Click hereDrivetrain>U660E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:

After the ignition switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53295E 3.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17752 4.REMOVE INLET NO. 2 AIR CLEANER

Hide 5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 6.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 17751 9.REMOVE INLET NO. 1 AIR CLEANER

Hide 10.REMOVE TCM

a.
C239666

Turn the lock lever and disconnect the connector from the TCM.


b.
C241670

Remove the 2 bolts and TCM from the automatic transaxle assembly.