51100G
1.REMOVE FRONT FRAME ASSEMBLY
12360
2.REMOVE FRONT ENGINE MOUNTING INSULATOR ASSEMBLY
12372A
3.REMOVE ENGINE MOUNTING INSULATOR LH
12362
4.REMOVE ENGINE MOUNTING INSULATOR RH
48829A
5.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
48824A
6.REMOVE FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as the LH side.
7.REMOVE FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY
Remove the front stabilizer bar with 2 front stabilizer link assemblies from the front frame assembly.
8.REMOVE STEERING LINK ASSEMBLY
48069
9.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
48068
10.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
51227B
11.REMOVE FRONT SUSPENSION MEMBER DYNAMIC DAMPER
Remove the 2 bolts and front suspension member dynamic damper from the front frame assembly.
52213A
12.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING FRONT STOPPER
Remove the 2 front suspension member body mounting front stoppers from the front frame assembly.
52216B
13.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING REAR STOPPER
Remove the 2 front suspension member body mounting rear stoppers from the front frame assembly.
52211J
14.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING FRONT CUSHION
| *1 | Front Suspension Member Body Mounting Front Cushion |
Install SST as shown in the illustration.
| *a | Turn |
| *b | Hold |
Using SST, remove the front suspension member body mounting front cushion from the front frame assembly.
Make sure that the claws of SST are securely hung onto the mounting cushion.
Tighten SST slowly and evenly.
Be careful as the mounting cushion may fly out.
The mounting cushion cannot be reused.
52217E
15.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION LH
| *1 | Front Suspension Member Body Mounting Rear Cushion LH |
Install SST as shown in the illustration.
| *a | Turn |
| *b | Hold |
Using SST, remove the front suspension member body mounting rear cushion LH from the front frame assembly.
Make sure that the claws of SST are securely hung onto the mounting cushion.
Tighten SST slowly and evenly.
Be careful as the mounting cushion may fly out.
The mounting cushion cannot be reused.
52215
16.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION RH
Perform the same procedure as the LH side.
17.REMOVE HOLE PLUG
Remove 9 hole plugs from the front frame assembly.