1.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
2.REMOVE REAR SEAT CUSHION LOCK HOOK
3.REMOVE REAR SIDE SEATBACK ASSEMBLY LH
86011R
4.REMOVE RADIO SETTING CONDENSER (for High Mounted Stop Light)
When the terminal covers are removed, the radio setting condenser must be replaced because the terminal covers and condenser are supplied as a set.
Remove the bolt.
Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
Disengage the claw and pull out the cover as shown in the illustration.
Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.
Using a screwdriver, bend back and break off the claw as shown in the illustration.
Remove the terminal cover from the wire harness.
Make sure to hold the wire harness on the crimping side of the terminal when disconnecting the wire harness from the terminal cover.
Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.
Check for deformation of the terminal after the wire harness has been removed from the terminal cover.
62332A
5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Window Defogger)
62472A
6.REMOVE ROOF SIDE INNER GARNISH LH (for Window Defogger)
86011Q
7.REMOVE RADIO SETTING CONDENSER (for Window Defogger)
When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.
Remove the bolt.
Disengage the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.
Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.
Using a screwdriver, bend back and break off the claw as shown in the illustration.
Remove the terminal cover from the wire harness.
Make sure to hold the wire harness on the crimping side of the terminal when disconnecting the wire harness from the terminal cover.
Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.
Check for deformation of the terminal after the wire harness has been removed from the terminal cover.