Home › Power Source / Network › 2GR-FE BATTERY / CHARGING › GENERATOR
RM2030EQ _57 Power Source / Network _014661 2GR-FE BATTERY / CHARGING _0074570 GENERATOR A

2GR-FE BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 11209 3.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 16400 4.REMOVE RADIATOR ASSEMBLY

Hide 27020 6.REMOVE GENERATOR ASSEMBLY

a.
A255477

Remove the terminal cap.


b.

Remove the nut and disconnect the wire harness from terminal B.


c.

Disconnect the generator connector from the generator assembly.


d.

Remove the bolt and disconnect the wire harness clamp.


e.
A255479

Remove the 2 bolts.


f.
A255478

Remove the 2 bolts and generator assembly.


g.

Disconnect the wire harness clamp and remove the generator bracket.