Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART ENTRY AND START SYSTEM(for Start Function) › 2012.02–2014.05
RM2030EQ _58 Vehicle Interior _014665 THEFT DETERRENT / KEYLESS ENTRY _0074592 SMART ENTRY AND START SYSTEM(for Start Function) S

THEFT DETERRENT / KEYLESS ENTRY  SMART ENTRY AND START SYSTEM(for Start Function)  DIAGNOSTIC TROUBLE CODE CHART  


Smart Entry and Start System (for Start Function)
DTC No. Detection Item Note Link
B2271 Ignition Hold Monitor Malfunction DTC Output Confirmation Operation

Turn the engine switch on (IG).


HINT:

To turn the engine switch on (IG), carry the electrical key transmitter sub-assembly and press the engine switch twice with the shift lever in P and the brake pedal released.


Click here
B2274 ACC Monitor Malfunction DTC Output Confirmation Operation

Wait 10 seconds after turning the engine switch on (ACC) or on (IG), and then wait another 10 seconds after turning the engine switch off..


Click here
B2277 Detecting Vehicle Submersion DTC Output Confirmation Operation

Wait 300 seconds after connecting the cable to the negative (-) battery terminal.


Click here
B2282 Vehicle Speed Signal Malfunction DTC Output Confirmation Operation

Drive the vehicle for 20 seconds at a vehicle speed of 25 km/h (16 mph) or more, and then drive the vehicle at a vehicle speed of less than 5 km/h (3 mph) for 20 seconds.


Click here
B2283 Vehicle Speed Sensor Malfunction DTC Output Confirmation Operation

Run the engine at an engine speed of 2000 rpm or more for 330 seconds.


Click here
B2284 Brake Signal Malfunction DTC Output Confirmation Operation

Connect the cable to the negative (-) battery terminal, release the brake pedal and wait 20 seconds or more. Then depress the brake pedal for 20 seconds or more.


Click here
B2285 Steering Lock Position Signal Circuit Malfunction DTC Output Confirmation Operation

Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and then reconnect the cable to the negative (-) battery terminal. Wait 40 seconds or more with the engine switch off (with the steering wheel locked), then turn the engine switch on (ACC) (with the steering unlocked) and wait 40 seconds or more.


Click here
B2286 Runnable Signal Malfunction DTC Output Confirmation Operation

Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and reconnect the cable to the negative (-) battery terminal. Wait 20 seconds or more with the engine switch off, then start the engine and maintain an engine speed of 1000 rpm or more for 20 seconds or more.


Click here
P0335 Crankshaft Position Sensor Circuit Malfunction (NE Signal) DTC Output Confirmation Operation

Allow the engine to idle for 10 seconds or more.


Click here
U0100 Lost Communication with ECM / PCM DTC Output Confirmation Operation

Turn the engine switch on (IG) and wait 10 seconds or more.


Click here
U0140 Lost Communication with Main Body ECU DTC Output Confirmation Operation

Always


Click here
U0155 Lost Communication with Combination Meter DTC Output Confirmation Operation

Turn the engine switch on (IG) and wait 10 seconds or more.


Click here